Products Gaskets
Flexiteck Spiral Wound Gaskets are manufactured in Round, Obround, Square, Oval, Diamond and Pear shapes. Sizes : All sizes available for ANSI, API, JIS, MSS & DIN Flanges.
Suitable for use across a wide pressure range and is therefore virtually universally applicable. Can be use to seal fluid pressures up to 250 bar and cryogenic temperatures as low as -200ºC and up to elevated temperatures of 1000ºC.
 Due to its sturdy design, the spiral wound gaskets is simple to install without causing damage. The outer guide ring serves to locate the spiral element centrally on the flange faces and prevent blow-out. By combining different winding materials and metals, the gasket can be tailored to a wide variety of operating conditions. Due to its non-adhesive character, the gasket is easy to remove after service. The gasket does not cause any damage to the flange faces.
API Ring Joint Gaskets come in two basic types an oval cross section and octagonal cross section.
These basic shapes are used in pressures up to 10,000 psi. The dimensions are standardized and require sepcially grooved flanges. The octagonal cross section has a higher sealing efficiency than the oval and would be the preferred gasket. However, only the oval cross section can be used in the old type round bottom groove.
 The newer flat bottom groove design will accept either the oval or the octagonal cross section. The sealing surfaces on the ring joint grooves must be smoothly finished to 63 microinches and be free of objectionable ridges, tool or chatter marks. They seal by an initial line contact or a wedging action as the compressive forces are applied. The hardness of the ring should always be less than the hardness of the flanges. Dimensions for API ring joint gaskets and grooves are covered in ANSI B 16.20 and API 6A.
Products Flowmeter
Industrial Turbine Flowmeter
Description:
 COX Series 81 Ceramic Ball Bearing Industrial Turbine Flowmeters produce a high-resolution pulse rate output signal proportional to volumetric flow rate. COX Industrial ceramic dual ball bearing construction provides a robust bearing system and high shock internals. The Series 81 Meter is recommended for use with light, lubricating, hydrocarbon liquids and filtered water.
Series RT200/RT200-XP, Rate Meter & Totalizer
Description:
 COX Series RT200/RT200-XP is a battery-powered rate meter and totalizer with 4-20 mA rate output. An optional flow meter mounting kit allows for swivel adjustment to align to conduit or positioning of display.
Products MultiSkimmers
MARKLEEN MultiSkimmers are compact, lightweight units used for recovering all oil types. All components used in Markleen MultiSkimmers are robust and sea water and oil resistant.
Depending on the viscosity of the substance to be recovered, standard rotating brush Markleen MultiSkimmers may be converted to drum or disc skimmers in just a few minutes and without the use of tools. Thus Markleen MultiSkimmers offer the advantages of having three skimmers in one.
| 
